26
Operation
© Travis Industries
4141007
100-01402
Thermostat (T-stat) Mode
Thermostat (T-stat) Mode allows you to use the internal (or external) thermostat to control room
temperature. The heater automatically turns on when the temperature drops below the thermostat
setting and turns off (or to low) once the thermostat setting is met.
A wireless thermostat is available from Travis Industries (see your dealer for details).
Setting the Target Temperature
-
Internal (Built-In) Thermostat (available only when thermostat source is set to “Internal” - see page 30)
Press the Menu Button on the control panel. When the digital display reads “T-stat ##” the target
temperature is ready to be programmed. Use the Heat Setting Slider to adjust the target
temperature.
-
External Thermostat
Several external thermostats are available to control the pellet heater (wired, wireless, programmable,
etc…). Refer to the instructions included with the external thermostat to set the target temperature.
To Start the Stove in Thermostat Mode
Press the Thermostat Button on the touch screen. If there is a call
for heat from the thermostat, the stove will enter the start-up
sequence for approximately 20 minutes. When in Thermostat
Mode the Thermostat Button will display a green light.
To Adjust the Heat Output
Use the Heat Setting slider to adjust heat output.
NOTE:
Heat output may vary depending upon which TSTAT
program you are in. For details see “Thermostat Programs” on
page 27.
TIP:
If the stove turns on and off repeatedly, you may wish to turn the heat output to a lower setting.
This provides a more consistent heat output, eliminating the need for the thermostat to turn the heater
on and off.
To Shut Down
Press the On/Off Button on the touch screen. The heater will begin the shut-down process, which
takes approximately 45 minutes.
Heat Setting
Heat Setting
T-stat 72
Room Temperature 68°
