![background image](http://html1.mh-extra.com/html/look-solutions/viper-2-6/viper-2-6_operating-manual_1938902015.webp)
15
5. Operating the Viper 2.6
5.6 Wiring of the sockets
5pin XLR (DMX)
:
Pin 1 = Ground, Pin 2 = DMX –, Pin 3 = DMX +
3pin XLR (analog)
:
Pin 1 = Ground, Pin 2 = 0-10 V + DC in, Pin 3 = 12 V + DC out, max. 50 mA
5.5 Operating the internal timer
With the internal timer the „fog time” and ”wait time” as well as the output
can be adjusted.
The output of the fan has to be adjusted in the Standard-Menue and can‘t be
changed in the Timer-Menue.
To start the Timer-Mode, press and hold the Mode-button [16] for more than 2
seconds. The red Timer-LED [21] shines as soon as the machine has switched to
the Timer-Mode. As long as the timer is in operation, the red Timer-LED blinks.
The adjusting of the output, fog time or wait time is the same as in the Stan-
dard-Menu. That means you have to press the Mode-button until you reach the
required function.
With the Up/Down-buttons you can adjust the output (Pxx), fog time (F.xx) and
wait time (P.xx), then press the Enter-button to start the timer.
The timer cycle starts with the time last shown on the display (P.xx = Starts with
wait time, F.xx = Starts with fog time).
You can switch back to the Standard-Menu by pressing the Mode-button [16]
for more than 2 seconds or by switching to „ESC” (Escape) in the Timer-Mode and
then press the Enter-button.
5.5.1 Auto start
If the timer is in operation and you disconnect the machine from the mains
cable, the
Viper 2.6
will re-start in the Timer-Mode as soon as it‘s reconnected to
the mains. To stop this press and hold the Mode-button [14] for more than 2
seconds or switch to „ESC“ in the Timer-Mode and then press the Enter-button.