LONGHORN LHD8003, Руководство по установке

Страница: 9 / 33

Once all of the transmitters are registered, it is recommended that you test the chosen mounting
locations before permanently mounting the control panel and wireless devices. You can test the
transmitter signal strength using the TX Test feature.
To test wireless transmitters:
1. During disarm, press “PROG”, with voice guide “Enter password before setting parameters!”. Input the
installer code with “#” to enter.
2. Select “Service” “WL. Test” “#”.
3. Trigger the desired devices, and the info about them will display on the LCD.
4. After all test, press “
*
” to exit.
Test GSM Signal:
The communication signal strength should be tested to confirm if GSM module is connected.
To test the GSM signal:
1. During disarm, press “PROG” with voice guide “Enter password before setting parameters!”. Input the
installer code with “#” to enter.
2. Select “Service” “#” “GSM Test” “#”.
0-31 means for the signal strength. 31 means the strongest. To make sure normal communication,
please use over 12.
→
“#”
→ →
→ → →
At first, stick “Installing Hole Drawing” on the location for control panel. Drive 4 screws on the fixed position
(see Figure 11-1), and then hang the control panel directly on the screws(see Figure 11-2). While driving
the screws, please pay strict attention to the depth of screws to make sure easy hang and tamper switch
work normally. There are 2 tamper switches: front tamper and rear tamper. Compress the tamper switch
while installing. If the control panel is removed or opened, tamper alarm will be triggered.
-13-
-14-
Figure - -1 11 Figure - -2 11
Installing Hole Drawing
Wall Wall
While hanging the control panel, please don’t shake the product to avoid breaking the tamper switch.
Chapter 5: Operations
5.1 Front Panel Layout
Figure - - 12
AWAY
STAY
DISARM
PROG
4.3.5 Register Transmitters
Transmitters refer to wireless devices such as detector, magnetic switch, siren and keyfob, etc.
can transmitters be recognized by the control panel.
To register a device:
1. During disarm, press “PROG”. With voice guide “Enter password before setting parameters!”. Input the
installer code with “#”.
2. For specific register process, pls refer to “WL. Register, Keyfob Register and WL. Siren Reg.”.
Only after
enrolling
4
.3.6 Testing the Chosen Mounting Location
Having chosen and tested the mounting location of the control panel and each transmitter, you are now ready
to permanently install the system.
4.3.7 Installing the Control Panel
Please take off the battery before enrolling, and then enroll one by one with battery connected.
While you register with battery on for all devices, there may come wireless signal interference
and make enroll fail.
Note