LONGHORN LHD8003, Руководство по установке

Страница: 7 / 33

4.3.2 Power off and Inser t SIM Card
SIM card must be inserted for GSM or SMS alarm via GSM module. The AC power and battery must be cut-
off for safe operation.
Steps:
1. Plug the AC power adaptor and battery flat-cable.
2. Push off the SIM buckle lightly, see Figure 7.
3. Insert the SIM card.
4. Lock it.
4.3 Installation Procedure
After unpacking the kit and making sure that you have all the necessary equipments, it is recommended
that you install the system as following:
Step 1: Open the housing.
Step 2: Make sure power is cut off, and insert the SIM card.
Step 3: Connect external devices.
Step 4: Power the control panel.
Step 5: Register the transmitters(wireless detector, magnetic switch, siren and keyfobs, etc.
Step 6: Test the communication signal of chosen mounting location..
Step 7: Permanently install the control panel and transmitters.
Figure -5-
TX
TX
RX
steel reinforced
concrete wall
brick wall
-09- -10-
4.3.1 Open the Housing
Figure - - 6
Figure - - 7
4.3.3 Exter nal Devices Connection
1. Wired Siren Connection
The max drive of BELL terminal is 400mA/12VDC. Connect the bell power line to “BELL” and “GND”. The
siren will beep once after powering on. You can try to program via keypad to set if the siren beeps and how
Note: The wired siren is invalid with only backup battery on.
Note
The reduction of the RF signals’ strength is directly proportional to the thickness of the
obstacle, assuming that the obstacles are of identical material.
Open the housing, press the control
panel buckle lightly to open it.
Note