London Electronics INTUITIVE INT4-P, Инструкция по установке и эксплуатации

Страница: 33 / 44

33
Set1
Set2 Output
Alarms
Digit
OK
Max/Min
Reset
Scale Factor adjustment
After you have calibrated your meter, you can use the SCALE feature to make fine adjust-
ments to calibration, without affecting the calibration itself, or you can convert to different
units of measure.
Examples
1.Changing weight units of measure from kg to pounds
You can use the SCALE feature to convert your readout from kg to pounds, without affecting
the calibration. Simply set SCALE = 2.205 and your meter which was calibrated in kg will
now read in pounds. (To convert from Pounds to kg, set scale = 0.453 )
2. Changing from Degrees C to Degrees F
0 Degrees C is +32 degrees F (A 32 degree F offset)
A change of 1 degrees C is equivalent to a change of 1.8 Degrees F (A scale factor of 1.8)
So, we set Scale = 1.8 and offset = 32 See next page for offset setting.
3. Changing from Degrees F to Degrees C
0 Degrees F is -17.8 degrees C (A -17.8 degree C offset)
A change of 1 degrees F is equivalent to a change of 0.555 Degrees C (A scale factor of
0.555) So, we set Scale = 0.555 and offset = -17.8 See next page for offset setting.
Lockout Switch must be OFF
Press 3 seconds
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Press repeatedly until you see
SCALE , followed by the existing scale
factor. (Default = 001.000 )
1
2
3
4
Set1 Set2 Output Alarms
Digit OK
Max/Min Reset
Use DIGIT button to select each digit
in turn, UP or DOWN buttons to
increase or decrease each digit’s
value. Press OK when done.
Set1
Set2 Output
Alarms
Digit
OK
Max/Min Reset
Done!
You may want to adjust an offset value also, see separate OFFSET page for this feature.
Press to accept
OFF
Circuit board ON