8
WARNING!
The layout of the workplace is
important for safety. Please note the following:
Choose a location for the machine with a hard
and flat surface. Set up the machine on a flat
surface with at least 5 m of free space around
the machine without obstacles.
Operation of the planer requires proper work
lighting.
Keep the workplace free of debris, pets,
children, obstacles and anything else that may
distract the operator.
Always have a hand-held, ABC type (min. 3
kg) fire extinguisher readily accessible at the
workplace.
Always have a complete first aid kid accessible
at the workplace.
• If the wheel set is not used, secure the machine
with bolts through the chassis holes.
• Make sure that there is sufficient free space on
the in-feed and out-feed sides for the longest
boards to be planed and that there is space for
servicing and wood storage.
• Connect the chip hoses (3 pcs) and fasten them
with hose clamps on both the machine and the
chip extractor.
• Suspend the power cable to the planer from the
ceiling or protect it in another way. Never step
on the cable. The machine should be connected
via an earth leakage circuit breaker.
• Make sure that there is good lighting. There
must be good general lighting. Install a power-
ful light just above the machine. Make sure that
there is no risk of being blinded by the glare.
SETTING UP
SETTING UP
CHIP COLLECTION
If the wheel set is mounted on the machine:
• Make sure the underlying surface is smooth
and flat. Take measures to counteract level
differences or sloping floor surfaces to prevent
unpredictable machine movement due to
gravity.
• The machine must not be used at temperatures
below 0 ° C.
• The machine's warning markings are there
for your own and other's safety. Damaged or
illegible labels must be replaced.
Moving the machine:
• The machine can be transported with a forklift
or pallet mover. It must be placed and secured
on a EUR-pallet.
• A wheel set that is mounted under the machine
is available as an accessory from Logosol for
moving the machine on flat and level surfaces.
The Logosol CH3 must be connected to a chip
extractor with a capacity of at least 2500 m3/h.
Remember that you must have an air outlet in your
chip container (e.g. a fine net or filter if you have
chip collection indoors). Poor suction is often due
to poor airflow from the chip container. If you are
working in a heated room, keep in mind that the
collector will quickly cool the room if the air is not
returned.
Fire risks and chip emissions associated with chip
collection must be taken into consideration.
Fire risk and chip emissions associated with
chip collection.
Contact the local authorities for advice on the
applicable local regulations.
Connect the chip hoses and secure them with
hose clamps to both the planer and the chip
extractor. Use Flexi hose from Logosol for best
results.
If you want to transport the chips a longer
distance: Place the extractor near the planer, so
that the hoses are as short as possible. Collect
the chips through a sheet metal pipe that has
lower airflow resistance.
Position the chip extractor so that its switch is
easily accessible.
