7
LOGOSOL CH3
PLANER
USE
WARNING!
Cutting knives: The planer can
cause serious bodily injury if improperly used
WARNING!
Cutting knives: Never insert hands
or knives into the machine during operation.
WARNING!
Risk of crushing. Never stand in
the path of a board. The board can be thrown
back out of the machine. Chips, knots and
steel fragments can also be ejected at high
speed.
WARNING!
Never modify this machine
so that it no longer conforms to the
original configuration. Use only LOGOSOL
manufactured products or those expressly
approved by LOGOSOL for the purpose when
adding extra equipment.
WARNING!
Risk of ejection. Never stand in the
path of a board. There is a risk of the board
being thrown back out of the machine. Knots,
splinters or pieces of metal can also be ejected
at high speed.
Always stand to the side of the work table
when operating.
The object fed into the machine must have
a length of at least 600 mm to prevent the
workpiece from twisting between the feed
rollers and fastening in the machine.
Make sure that the machine has been properly
assembled and maintained in line with the
assembly instructions and maintenance
instructions in this user manual.
Never work alone. Always make sure there is
another adult within hearing distance in case
you need to call for help.
BEFORE EACH USE:
Check that:
• The operator is wearing the prescribed personal
protective equipment.
• The prescribed maintenance has been carried
out.
• The machine has been set up so that it is stable
and has support along its entire length.
• Everything on the planer is properly tightened
and is in proper working order.
• All the safety equipment on the machine is in
place and in proper working order.
Before starting the machine:
• Make sure that no one other than the operator
is in the risk zone.
• Check that the cutters can rotate freely and that
no knives or unattached parts have been left in
the machine.
• Check that all knobs, screws, nuts, bolts, guides,
cutter wedges, cutters, knives, protective covers,
in-feed and out-feed tables, etc. are properly
tightened.
• Check that the feed is in the right direction.
Seen from the in-feed side of the machine, the
feed should rotate clockwise. If the feed is in the
wrong direction, reverse the direction by turning
the pins in the contact with a flat screwdriver.
• Check that the cover is properly closed, that all
chip couplings are fitted and the chip extractor
is switched on.
SAFETY INSTRUCTIONS
RISKOMRÅDE
OPERATÖRSOMRÅDE
6M
3M
3M
8M
OPERATOR’S WORKING AREA
