Logitech Electronics 2000 MKII Series, Руководство пользователя, Страница: 12 / 17

Alteration of Programmable Parameters
The programmable parameters can be accessed at any time by momentarily pressing the RUN/SET
button once. This will cause the mode to change from the normal RUN mode to the SET mode. The
unit will normally display SET …. TOTAL …. SCALE .... followed by the current value
programmed for the total scaling value. The value set for FACTOR may be protected (see below).
If the Factor or Scaling Value is changed after the instrument has been in use operationally, then
TOTAL should be reset prior to using the instrument with the revised programming to avoid the
possibility of an incorrectly displayed value which has been held in memory from use with the
previous settings.
Protection of Factor Value
Remember that the value entered for FACTOR can only be accessed by connecting a link on the rear
terminal block between M0 (terminal 7) and 0V. When the RUN/SET button is pressed while this link
is in place the unit will display S ET …. FACTOR .... followed by the current value programmed
for FACTOR . This value can then be changed and all other programmable parameters are
accessible, as before (see Programming the Instrument on page 8), by pressing the FUNC button.
2000CT-
MKII
_hb v3.1 01/2020 ! 12