13
MOUNTING THE SENSOR ON A POLE
1. Stick the rubber pads on the inside of the mounting clamp and mounting base of the sensor.
2. Insert two (2) screws into the mounting base and clamp. Then, loosely tighten the screws using
included nuts.
3. Place the mounting fixture over a pole (not included).
4. Tighten all the screws so the sensor sits firmly and securely on the pole.
NOTE: Place the mounting base and clamp on a steel pole or post with a 1.2″ – 1.6″ (30 – 40 mm)
diameter and is a minimum of 6.6' (2 m) off the ground.
When setting up the outdoor sensor, make sure the rain collector side is facing north.
When placing the outdoor sensor, make sure it is within 492' (150 m) of the display console.
4
INSTALLATION AND SETUP
Your console can pair up with one wireless 7-in-1 outdoor sensor and up to 7 wireless indoor
sensors. (1pc wireless indoor sensor included)
INSTALL WIRELESS 7-IN-1 SENSOR
Your wireless 7-IN-1 sensor measures wind-speed, wind-direction, rainfall, UV, light intensity,
temperature and humidity for you. It’s assembled and calibrated for your easy installation.
INSTALL RAIN COLLECTOR
Rain Collector Installation
1 Align
Lock grooves
2 Lock
INSTALL BATTERIES
Unscrew the battery door at bottom of unit and insert the batteries
according to the +/- polarity indicated. Screw the battery door
compartment on tightly.
NOTE:
Screw
location
3 x AA
batteries
MOUNTING POLE AND DIRECTION ALIGNMENT
Install the wireless 7-IN-1 sensor in an open
location with no obstructions above and around the
sensor for accurate rain and wind measurement.
Install the sensor with the smaller end facing the
North to properly orient the wind direction vane.
Secure the mounting stand and bracket (included)
to a 35 ~ 40mm diameter steel post or pole, and
allow minimum 2m off the ground.
Point to
SOUTH
Point to
NORTH
2 meters
off the
ground
mounting pole
and stand not
included
Add rubber
pad before
mounting on
pole or post
9
Step 1: Loosen the screw lightly until the gears on the
opposite side separated from lock position .
Step 2: Adjust the vertical angle of the solar panel (0°,
15°, 30°, 45°, 60°) according to the latitude of your
location .
Step 3: Push the gear and tighten the screw until the
gears are securely locked .
3.1.4 INSTALL MOUNTING POLE
1 . Stick the 2 rubber pads (provided) onto the inner sides of the mounting part
2 . Insert the 2 screws into the sensor array mounting base and hand tighten the screws
3 . Place the sensor array over the mounting pole and align the sensor array to North direction
4 . Tighten the screws to fit the size of your mounting pole
Add rubber pad
before mounting
on pole
