SPACE 2000 (T and M versions) OPERATION MANUAL
17
Average point calculation
This function can be used for a relative zero-setting of the display of the axis at
the center of two points measured previously.
This function is used for centring inside a hole or to define the center of a
plate.
Necessary conditions :
-
absolute or relative zero-setting must have been performed for the axis in question
-
the axis must have been shifted after zero-setting in order to define the segment for which the
average point will be calculated
-
the SPACE 2000 must be set in position display conditions ("POS" LEDs on)
Select the function by pressing the
following keys :
The
“F3”
message
appears on
the X-axis display to indicate the
choice of the function to be
enabled.
All the LEDs except PWR and the
displays of the other axes are
switched off. The indication of the
origin/tool remains enabled.
In order to quit this selection and
return to the position display, press
the key :
In order to enable the function
selected, press:
The X-axis display will show the
“SEL. ASSE”
message in order to
inform the operator to select the
axis for the execution of the
function selected.
In order to quit this selection and
return to the position display, press
the key :
Select
the
axis
involved
by
pressing any of the keys:
T version
M version
The display of the axis selected will
show
the
distance
from
the
average point.
Now when the axis is brought to
zero, it will be exactly at the center
of the position displayed prior to
the use of the “
F3
” key.
The displays of the other axes and
the respective LEDs return to
normal in order to show the
operator that calculation function
has been concluded.
F
3
F
3
F
E
nt
F
X
Z
Z
1
X
Y
Z
W
