SPACE 2000 (T and M versions) OPERATION MANUAL
23
MACHINE PARAMETER PROGRAMMING
(M.P.)
This command permits the programming of the machine parameters that define
SPACE 2000 functionality.
The operations described in this paragraph are usually used during the
installation and initial operation of the SPACE 2000 most often conducted by
LOGAN technical personnel.
Whenever possible, machine parameter programming has already been
performed by LOGAN in accordance with the supply specifications: for this
reason, the information in this section is provided only for reference.
Entry into the SPACE 2000
machine
parameter
table
is
obtained by keeping the following
key pressed:
during switch-on until the first
parameter appears.
The first parameter
“P00”
appears
on the X-axis display together with
its value.
All the LEDs except PWR and the
displays of the other axes are
switched off.
The indication of the origin/tool is
also disabled.
Each time the following key is
pressed:
the SPACE 2000 runs a coherence
check on the parameter.
If the parameter is considered
correct, it is memorised and the
next parameter appears on the
display.
Whenever incoherence is found,
the display provides the “
Par. inc.
”
error message for around 2
seconds and then shows the wrong
parameter for correction.
In order to quit M.P. programming,
press:
The X-axis display will show the
“OFF - ON”
message.
Switch the SPACE 2000 off and
then on until it resumes normal
operation and any parameters
modified are enabled.
On
F
F
F
E
nt