LOFTNESS 601TR4000, Руководство оператора / Каталог запасных частей

Страница: 15 / 37

Owner’s Manual (Toro GM4000 Series Snowblower)
N14869 2 - November, 2004 3
Set-up and Operating Instructions Continued
Switch Decals:
Figure 8
Switch decal (supplied with wire harness kit) are cut
out graphics which only represent the snowblower
operation. Approximate size is shown by dotted
lines in figure 10. Each decal should be
approximately 1” by 1-1/4”.
Note:
Check switch operation and reverse their
locations in control console if they don’t operate
in direction shown on decals. Tighten toggle
switch nuts
Install control panel housing and secure with knobs.
Adjusting the Cutting Unit Flow Control:
The flow control valve (Figure 9) is used to adjust
the rate at which the snowblower lowers.
•
Loosen set screw on flow control valve,
(shown as #1) adjust valve as desired and
tighten set screw.
Figure 9
Adjust Lift Pressure
•
Loosen jam nut on lift pressure adjusting
screw.
•
Adjust lift pressure screw to attain 2000 psi
minimum.
•
Tighten jam nut on lift pressure adjusting
screw. (shown in figure 10 with item #1 as
the control valve and Item #2 as the lift
pressure adjusting screw)
Figure 10
•
Return control valve to original pressure
setting (Refer to Toro Operator’s Manual)
when removing the snowblower and
reinstalling the cutting unit.
Hydraulic Hose Storage:
Attach the pressure line and return line hoses to the
hydraulic motor on the snowblower. Unused
hydraulic hoses or outlets used for other
attachments will be capped and plugged, using the
Cap & Plug Kit (P/N N15349). Store under traction
unit and secure with cable ties.
Note:
Store unused hoses under traction unit and
secure with cable ties. Avoid any contact with
sharp edges or moving parts.
Operating:
The Loftness snowblower is an effective, reliable
machine used for the removal of snow. Before
operating this machine, become familiar with and
study all the hazard warning and safety precautions
listed in this book.