LOFTNESS 601TR4000, Руководство оператора / Каталог запасных частей

Страница: 14 / 37

Owner’s Manual (Toro GM4000 Series Snowblower)
N14869 2 - November, 2004 2
Set-up and Operating Instructions Continued:
Wiring Harness Installation:
Attach the wiring harness for the electric spout
control (figure 4) per illustration in section 4, page
4-7. Loftness will provide the wiring harness (P/N
N15370) from the spout and an additional wiring
harness, purchased from Toro (Toro P/N 95-3263),
will be used to provide power from the traction
unit to the electric spout control. (disregard wiring
instructions included with Toro wiring harness kit):
Mounting holes may be provided for the toggle
switches. Follow the directions shown below if the
mounting holes are not in the control panel:
•
Remove (4) knobs securing control panel
housing to frame control console. Remove
housing (Item #1 figure 5)
Figure 5
•
Mark and drill (2) .50” holes in top of
control console per dimensions shown in
figure 6.
Figure 6
•
Loosely mount a toggle switch in each hole
with washer and nuts supplied.
•
Plug (2) wire harness terminals onto toggle
switch terminals and attach decals (Item #1
figure 6 – reference figure 8 page 2-3).
•
Plug harness terminal onto traction unit
accessory wire harness connector (located at
fuse block).
•
Secure ring terminal wire of harness to screw
on capacitor with black wire. Capacitor is
located near fuse block.
•
Affix the mounting pads to underside of
operator platform at locations shown in
figure 7. Clean surface well before affixing
pads (Item #1 figure 7).
Figure 7
•
Insert a cable tie through each of the plastic
mounting pads.
•
Insert end of harness through hole in
operator platform and secure with cable ties.
•
Plug harness connector into connector on
snowblower harness.
•
Install and label (1) 10 amp fuse block
breaker socket for Implement and (1) 25
amp breaker fuse block socket for Thermal.
Note: Wires must not contact any sharp edges
or moving parts.