Loewe POWER STATION LW-IR-001, Инструкция по эксплуатации

Страница: 18 / 46

18
FILLING WITH WATER
• Ensure that the iron is disconnected from the power supply before filling.
• Keep the iron horizontal and rest it on its rest support (10). Fill the boiler using the measure (12)
and its funnel (11) provided (Fig. B).
• Ensure that the amount of water never exceeds 300 ml which is the exact amount indicated on
the measure.
• If there is too much liquid in the iron boiler, water will leak and/or spurt from the steam outlet holes
when you begin ironing.
• Do not fill the boiler tank with chemical additives or other perfuming or decalcification agents.
• Empty the boiler after use. Rinse with water and empty the boiler again. Store the appliance with
the safety cap (1) open.
• It is recommended that you leave the safety cap (1) open and heat the appliance so that the re-
maining water evaporates.
BEFORE IRONING
The safety cap (1) must be screwed onto the boiler tightly. This however does not mean tightening
it too much. As soon as the cap reaches its end of travel, apply just light pressure to make sure it is
closed. Forcing the closing of the cap by tightening it too much may cause the seal to break, which
may cause steam to escape from it. It is recommended to use the provided cap remover (3) for
opening and closing the safety cap.
HOW TO START THE APPLIANCE
• Insert the plug into the outlet. Turn on the iron. Press switch (7) to “ON” (Fig. C).
• When the warning light (5) goes on, the iron is heating up.
• Wait 4-5 minutes until the indicator light turns green.
• Now you may start to iron.
STEAM OUTFLOW
You can use the shot of steam or continuous steam for steam ironing.
• To deliver shots of steam, just press the steam button (4) Fig. D with more or less pressure, de-
pending on the intensity of steam you want to deliver.
• Turn the steam control knob (2) in a clockwise direction (Fig. E) to obtain a constant and conti-
nuous steam outflow. In this way you get a constant and continuous flow of steam up to maximum
intensity with complete rotation. You can get a greater intensity of team also during continuous
delivery by pressing the steam button (4) all the way down.
• Continuous steam supply is advised against: the boiler empties very quickly and it will not be pos -
sible to ensure a good intensity of steam delivery.
• Pay attention to never turning the iron upside-down and to not tilting it too far forward or sideways
both when delivering shots of steam and continuous steam.
WARNING!
Always stop the steam outflow before resting the iron on the separate stand (10).
NEVER UNSCREW THE SAFETY CAP (1) DURING USE. TURN OFF THE APPLIANCE BEFO -
RE OPENING THE SAFETY CAP. UNPLUG IT FROM THE ELECTRIC OUTLET. PRESS THE
BUTTON (4) ALL THE WAY DOWN TO ELIMINATE THE STEAM REMAINING IN THE BOILER.
EN