Loewe 3D Orchestra 3.1 IS, Руководство по эксплуатации

Страница: 24 / 116

3D Orchestra
Instruction manual
English
24
„
Extending the 3D Orchestra system
Subwoofer
Extending the 3D Orchestra system
You can extend an existing 3D Orchestra sound system (e.g. a 3.1 or
5.1 system) with further 3D Orchestra speakers or 3D Orchestra sub-
woofers. The maximum configuration is a 3D Orchestra 7.4 system.
Connect (see page 20) and reset (see below) the additional 3D
Orchestra speakers. Then carry out the automatic room acoustic
measurement as described on page 22. The additional 3D Or-
chestra speakers are integrated into the existing system.
Then connect (see page 20) and reset (see below) (all) the addi-
tional 3D Orchestra subwoofers. Then repeat the automatic room
acoustic measurement as described on page 20 for the integration
of the additional subwoofer(s).
Resetting 3D Orchestra components
If you wish to relink your 3D Orchestra speaker and subwoofer or
cancel an existing coupling with the Module 3D Orchestra Controller,
you can reset the 3D Orchestra components.
To do so, press the reset button (R) with a bent paperclip. On the 3D
Orchestra speaker, the reset button is in the shaft pole at the bottom
of the speaker.
The built-in white LED in the 3D Orchestra speaker flashes slowly after
the reset. This indicates that the speaker is ready for a new coupling.
On the 3D Orchestra subwoofer, the reset button is attached to the
panel at the rear side of the subwoofer.
R
Line In
Bass
Intensity
Subw
+12dB -12 dB
RF Reset
0
I
R
Using the subwoofer for other audio systems
Via the RCA jack Line In / Subw the 3D Orchestra Subwoofer can be
used in other audio systems as well. Connect the Line In / Subw jack
via a cinch cable to the Subwoofer/LFE connector of the audio source.
The 3D Orchestra Subwoofer is an active subwoofer. Therefore, it
may only be connected to a preamplifier output of the audio source.
After 10 minutes without an audio signal at the Line In / Subw jack,
the subwoofer will be switched off automatically.
The subwoofer can switch on automatically if interfering signals are
present on the audio lines. In this case, actuate the mains switch
of the subwoofer.
The subwoofer can switch off automatically during longer, very quiet
periods. In this case, increase the volume.
Bass intensity
Using the Bass Intensity controller you can set the basic bass volume
to suit you, when you operate the subwoofer via the RCA socket with
an analogue audio signal.
In the wireless operating mode, this controller has no function.
Line In
Bass
Intensity
Subw
+12dB -12 dB
RF Reset
0
I