Loctite 97121, Руководство по эксплуатации

Страница: 42 / 47

42
6.2.2.2 Mounting the Product Feedline in the Pinch Valve
• Unscrew the sleeve nut 12 from the threaded stem 11 of the valve assembly 1 .
• Insert the hose preassembled according to Section 6.2.3.1 to the stop
through the valve assembly 1 on the reservoir lid and tighten the sleeve
nut 2 .
• Slide on the plastic cone 13 in the correct position.
Do not kink the product feedline
when cutting since this can damage it.
• Screw the sleeve nut 12 under the reservoir lid onto the threaded stem 11
and tighten (see Section 4.1.1).
☞
Allow the product feedline approx. 2 minutes to return to its original length.
• Cut off the product feedline 4 in the product reservoir according to Section 4.1.1 at an angle
according to the dimensions given.
• When changing the product feedline, also
replace the thrust piece 10 and the rubber pad.
• Press the actuator assembly 7 against the
spring pressure of the valve piston into the valve
assembly
1 .
• Screw in the set screw 8 with the hexagon
socket key to the stop and then only an
additional approx. 15° for tightening so that
the movement of the valve piston is not impeded.
• Connect the valve.
☞
• Ensure that the reservoir is not under pressure!
• On the control unit, press the button to bring the valve piston to the maximum stroke position.
Without reservoir pressure, no product flows!
• With the button pressed, screw in the hexagon socket set screw 8 to the stop.
• Release the button and lock the hexagon socket set screw 8 with the hex-nut 9 .
Care, Cleaning and Maintenance 6
Pinch Valve with Applicator Pencil
• Assembling the Applicator Pencil according to
Section 4.1.2
• Connecting to the Controller according to Section
4.3
• Dispensing according to Chapter 5.
Pinch Valve as Stationary Applicator Unit
• Connecting to the Product Reservoir according
to Section 4.2.1.
• Connecting to the Controller according to Section
4.3.
• Dispensing according to Chapter 5.