Loctite 97105, Руководство пользователя

Страница: 33 / 40

33
Dispensing 5
5.2 Refilling the Product Reservoir (Replacing the Product Bottle)
Never completely empty the bottle in the reservoir! The entry of air into the product line
causes problems with dispensing.
☞
When air bubbles occur during dispensing, check if the product reservoir is empty.
●
For the dispensing of cyanacrylate adhesives, refill the product reservoir immediately since
air in the product line results in curing of the product!
When using an automatic reservoir, starts can no longer be initiated after the empty message.
This prevents the entry of air into the product line.
Before loosening the cover screw fasteners, the reservoir must be depressurized
(pressure-free)! (see Section 5.1)
●
Loosen the cover screw fasteners 2 and remove
the cover 1 .
Product residue on the hose!
●
Place the cover 1 on the drip funnel.
●
Replace the empty product bottle or cartridge in the product reservoir with a full one.
☞
Automatic reservoir only:
●
Check that the product bottle inserted in the
bottle nesting block is pressed against the level
sensor (see Section 4.3).
●
Insert the product hose into the bottle and put on the cover 1 .
●
Uniformly tighten the cover screw fasteners 2 .
●
Set the depressurizing valve 5 to position (pressurize).
●
On the 97102 controller, switch the reservoir to active with the button .
On the 97103 controller, switch the reservoir to active with button or .
B A
XS2/IN: Controller
XS2/OUT:Tank B
max. operating pressure
8 bar
operating temperature.
0 to +50C
volume:
3,5 Liter
Loctite (Ireland) Ltd.
Made in G
erm
any
XS2/IN
XS2/OUT
P in