Lochinvar ARMOR 150, Руководство по обслуживанию

Страница: 10 / 36

1
Service
10
Service Manual
Display panel menu access
Table 1B
Use this procedure to access menus from the display panel
DISPLAY BUTTON OPERATION
Enter Menu Code:
0000
Hold for 5 seconds -- display will change
Press 9 times to change last digit
in readout to "9"
Press 2 times to move to the second
digit
Press 3 times to change second digit
in readout to "3"
MENU/EXIT
UP
PREVIOUS
UP
UP
Enter Menu Code:
000 9
Enter Menu Code:
0 09 0
Enter Menu Code:
0 09 3
PREVIOUS
Press 1 time to change to the first
digit
Enter Menu Code:
309 0
Press 5 times to change first digit
in readout to "5" Enter Menu Code:
309 5
Enter Menu Code:
INSTALLER CODE
Press to enter the code ENTER/RES
>A General
B N/A After 2 seconds, display shows menus
(press ENTER/RESET to select a menu)
flashing
>C Data Log
D Functions
Press 1 time to toggle menu listing
DOWN
>E WHR Settings
F N/A
Press 2 times to toggle menu listing
DOWN
>G Anti-cycling
H Control Modes
Press 1 time to toggle menu listing
DOWN
>I Circ. Pumps
J Service Noti.
Press 2 times to toggle menu listing
DOWN
If the code is entered incorrectly, the display will return to its previous mode. You will have to start over
at step 1 to enter the code.
COMMENTS
Digit shown underlined at left will
flash
Digit shown underlined at left will
flash
Digit shown underlined at left will
flash
Digit shown underlined at left will
flash
Digit shown underlined at left will
flash
Digit shown underlined at left will
flash
The words,
will flash while displayed "INSTALLER CODE"
The caret symbol, ">" highlights
the selectable line
The menu toggles to the next two
menu options
The menu toggles to the next two
menu options
The menu toggles to the next two
menu options
The menu toggles to the next two
menu options
If you enter a digit incorrectly, you can move to the digit by using the NEXT and PREVIOUS buttons
as needed until the digit you want is flashing. Then use UP and/or DOWN buttons to change the value.
To select a highlighted menu, press the ENTER/RESET button one time. The display will
change to the first parameter under that menu, with the first characters flashing.
WHR:OFF
OUT:125˚F
Press 1 time in normal operation
ENTER/RES
Water heater turns off (this ensures
uninterrupted programming)