Lochinvar AMP 200-18, Инструкции по установке, пусконаладке и обслуживанию

Страница: 8 / 12

8
4.6 SWITCHING ON THE CORREX
®
POWER ANODE

Refill the vessel.

Check for leaks around the Ti-anode connection.

Re-check all wiring.

Switch on the unit.

Ensure a solid green LED is showing on the front of the unit (check again after 5
minutes as a fault on the circuit may not show immediately).
5.0 MAINTENANCE

Check a solid green LED is showing on the front of the unit, this indicates the unit is
working correctly. If a BMS connection is made to the unit (see section 4.5) you must
still check the LED.

Remove the front cover and check the hours run meter is correct for the length of time
the unit has been installed.

If a solid green LED is present then no maintenance is required during annual
maintenance of the vessel.

If anything other than a solid green LED is showing then refer to section 5.1 Fault
Finding.