Lochinvar 140H, Инструкция по установке и руководство пользователя

Страница: 37 / 76

37
Page
4. Tighten the two
Fork terminals beneath the two Remote controller terminal screws on the back of the
main body. (Fig. D-1)
5. Cut out the inlet for the remote controller cable from the bottom of the main body.
(Fig. D-2)
6. Place the
Main body back on the Back plate , with the Remote controller cable running out of the
bottom inlet.
<How to connect the remote controller to the water heater>
1. Disconnect power supply from the water heater.
2. Take off the water heater’s front cover.
3. Locate the two terminals for the remote controller in the water heater. (Refer to the Fig. E-1 and E-2.)
4. Take off the back plate from the remote controller, and then attach the two fork terminals to the
connector base on the back side of the remote controller with two screws. Make sure the terminals are
firmly fixed. (See the above instructions for installation of the remote controller.)
5. Pull the remote controller cable through the hole at the bottom of the water heater’s casing.
6. Secure both controller cable terminals to the terminals on the computer board as shown below. (Secure
them underneath the screw terminals. No polarity.)
* Do NOT jump or short-circuit the cables, or computer will be damaged.
7. Replace the front cover securely.
Remote controller
terminals
Fig. D-1
Two fork terminals
Remote controller cable
Inlet for the remote
controller cable
Cut out
Fig. D-2
140H/240H/340H models
100209924
(TM-RE42)
Connect other end to these terminals
Fig. E-1
100209924
(TM-RE42)
Connect other end to these terminals
540H model
Fig. E-2
Installation
Installation Manual