Replacing and Installing a New Elevation Motor
Repair Instructions
(Elite 2&3)
Step 3.)
Hammer the Spring Pin down over the top hole of
the Elevation Link until it is flush with the link top and
bottom.
Step 4.)
Turn your power button back on, and adjust the
elevation so that the link is no longer horizontal (Match the
diagram below). Turn the Power off once in position.
5
Putting the Yoke Back Onto The Davit.
Step 1.)
Lift up the Yoke Assembly and slide onto the Davit
Assembly so that the Yoke Wheel portion of the yoke is on
the right of the Davit Center, and the Motor Support Bracket
is in-between the Davit Right and the Davit Center.
Step 2.)
Slide the long bolt threw the hole in the yoke,
which passes from the right of the yoke, all the way to the
left. (Please follow the diagram below which shows where
the yoke spacer long, and short, and washers belong.)
Using a Washer and the yoke bolt nut, tighten until the yoke
is secure. (*
Do NOT over tighten the yoke or your elevation
The Server wheels.
The Yoke Bolt being installed.
