LNS Turbo HB, Инструкция по эксплуатации

Страница: 32 / 39

5-2 CHAPTER 5: OPTIONS
TURBO HB
5.1. Air header
Please read the safety instructions provided at the beginning of this manual before
handling the following devices.
Do not drill holes in the conveyor without consulting LNS beforehand as this will invalidate
the warranty as serious damage can occur.
Depending on the machine, customer preference and application an air header may or may not be
supplied with your conveyor. The air header is designed to blow a stream of compressed air on to the
underside of the belt at the discharge of the conveyor to help remove any chips that may stick to the belt.
This is particularly useful to prevent small chips being carried down back into the conveyor and making
their way into the coolant tank.
The air header can come in two forms, with a solenoid control valve or without. The solenoid can be
supplied when a timer is used in the conveyor control. The solenoid automatically starts the air supply to
the air header when the belt is running and automatically stops the supply of air the air header when the
belt is not running.
Whether the air header is equipped with a solenoid valve or not the principal of operation and set up is
the same. If a solenoid valve is fitted it will be supplied factory fitted with electrical connection to the
control already completed. It is possible to retrofit the air header without a solenoid valve after the
conveyor has been installed to the machine to help with troublesome applications. The set up and
installation is shown below:
Item No. Description
1 Fixing Screw
2 Air Header tube
3 Adjusting Knob
4 Fixing Bracket
5 Quick release coupling (Connect factory air supply here)
6 Pressure Gauge (set to 1.4 Bar)
1
2
3
4
5
6