Billet Trim Tab Installation
Mount the tab:
If the Livorsi Trim Tabs are replacing
existing tabs, make sure to seal any
unnecessary holes on the transom. Use a
high quality marine sealer suitable for
underwater use.
Recommended sealant: Marine Grade
RTV / silicone sealant 4200 or 5200.
Use this same sealer and apply liberally
around each fastener, indicator wires and
between transom and upper trim plate. It is
recommended to apply the same sealant to
the inside of the boat.
You may want to apply a piece of tape to
the ends of the hydraulic thru hull fittings to
prevent debris from entering the openings.
If equipped with the electronic sensor
carefully feed the sensor wires thru the
transom.
Secure all mounting hardware.
Installing the pumps and hydraulic lines:
Select the location to mount the hydraulic pumps.
NOTE: Keep pumps as level as possible.
Once mounted, route the hydraulic lines from the tab to the pump. Make sure hydraulic lines
are routed and secured away from any moving components in the boat..
DOWN
Sensor wires
UP
Back view of mounting plate
4
of 1
2
LIT-TTEL-ML-INST
REV A
ECO 28610