Instruction manual
17
PLASTIC SURFACES
Wash with a soft cloth and hot soapy water solution. Rinse with water. Do not use abrasive cleaners, degreasers or
a concentrated barbecue cleaner on plastic parts.
COOKING GRID
Use a mild soapy water solution. Non-abrasive scouring powder can be used on stubborn stains then rinse with water.
CLEANING THE BURNER ASSEMBLY
Turn the gas OFF at the control knob and disconnect the cylinder.
Remove cooling grate.
Clean the burner with a soft brush or blow clean with compressed air and wipe with a cloth.
Clean any clogged ports with a pipe cleaner or stiff wire (such as an opened paper clip).
Inspect burner for any damage (cracks or holes). If damage is found, replace with a new burner. Reinstall the burner,
check to ensure that the Gas valve orifices are correctly positioned and secured inside the burner inlet (venturi).
In some cases your barbecue will light back because of an insect crawling inside the burner venturi or a spider
spinning its web inside the burner. This can be rectified by using a bottle brush inserted through the burner venturi
and pushing it into the burner over the burner length. If condition persists consult your gas dealer.
Note
: Never put water on the burners to extinguish, this can damage them.
