Page 12 of 24
Toll Free: 800-749-5783
www.platinumtools.com
3. Insert the Load Terminal Block Connector into the Load Terminal
Jack until it is seated firmly and lock tabs are fully engaged.
4. Strip the ends of another jumper wire and connect one end to
the Circuit Breaker (where the wire was removed in Step 1) and
the other end to the Source Terminal Block Connector so that it
is matched with Source Terminal “S1”.
5. Connect the Fault Trapper meter to the module using the
included Banana Plug Leader Cable.
To connect to 220VAC Standard Breaker (up to 40amps):
All connections to the Fault Trapper 40A In-Line Adapter Module are
made using supplied Plug-in Terminal Blocks Connectors, torque
screws to 7in-lbs:
1. Remove the two hot wires
from the breakers for the load
being tested and attach them
to the Load side of the Fault
Trapper 40A In-Line Adapter
Module with the black in Load
Terminal “L1” and the red wire
in Load Terminal “L2” using
the Plug-in Terminal Block
Connector.
2. Strip the ends of a black
jumper wire and connect
one end of the wire using
the Source Terminal Block
Connector Source at Source
Terminal “S1” and the other
end to the breaker terminal
where the black wire was
removed from in Step 1.
3. Strip the ends of a red jumper wire and connect one end of
the wire to the Source Terminal Block Connector at “S2” and
the other end to the breaker terminal where the red wire was
removed from in Step 1.
4. Insert the Load Terminal Block Connector into the Load Terminal
Jack until it is seated firmly and lock tabs are fully engaged.
5. Connect the Fault Trapper meter to the module using the
included Banana Plug Leader Cable.
Tel: (855) 346-3358
livewireinnovation.com
