Page 16 of 24
Toll Free: 800-749-5783
www.platinumtools.com
Fault Trapper. When powered on with
AC power the ignore location will be
shown on the screen and “IGN” will be
displayed in the lower left corner of the
screen.
Clearing an Ignore – To clear an
ignore location press and hold the
Ignore Button until “CLR” is displayed
on the screen.
6.
Test Results
- The Display button is used to show test results.
If the AC power connection is off the unit will use the 9 volt battery
to power on the display and show
the results from the last test. There
can be a “Breaker Trip” fault and a
“Non-Breaker Trip” fault. The voltage
icon will flash indicating that the fault
shown caused the breaker to trip. Tap
the Display button to cycle between
the two faults (if there are more than
one). Ft and M units can be toggled by
holding down the Display and Ignore
buttons for 3 seconds.
Tel: (855) 346-3358
livewireinnovation.com
