LIVARNO LUX 3000.063.060, Инструкция по сборке, эксплуатации и безопасности

Страница: 7 / 36

8 GB/IE/NI
Start-up / Maintenance and Cleaning / Disposal / Information / Warranty Safety / Start-up
The light bulb is not replaceable.
This light is not suitable for dimmer or electronic
switches.
Only use the light with the included LED-Driver
(model EIP021V0240PSS).
Prevent fire and injury
hazards
Do not look directly into the light source (light
bulb, LED etc.).
Do not leave the light or packaging lie about
carelessly. Plastic film or bags, plastic parts etc.
can turn into dangerous toys for children.
Never cover the light or the LED driver with ob-
jects. Excessive heat can result in fire.
Do not operate the lamp unattended.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
Always be attentive! Always pay attention to
what you are doing and proceed with caution
at all times.
Never assemble the lamp whilst unfocused or
feeling unwell.
Start-up
Mounting the light
Note: We recommend assembling this light with
2 persons. When assembling the lamp base and
the lower gooseneck lamp unit
3
, be sure not to
damage the power cord inside the light. Remove all
packaging material. You will also need a cross-tip
screwdriver.
Place the lamp base with the lower gooseneck
lamp unit
3
on the floor in front of you.
Carefully lift the aluminium baffle
1
approx.
30 cm out of the guide for the lower gooseneck
lamp unit. This will expose 4 bores.
Position these bores congruent over the assembly
bracket
4
for the lower gooseneck lamp unit.
Note: The internal power cord
2 b
must simul-
taneously be pushed into the lower gooseneck
lamp unit. Choose the ideal angle between the
power cord and the lower gooseneck lamp unit
when doing so. Hold the lower gooseneck lamp
unit perpendicular (Fig. B). Holding the power
cord below the connecting plug and carefully
pulling it up can help when inserting the power
cord.
Assemble the lower gooseneck lamp unit
4
with
4 cross-tip screws
5
and slide the aluminium
baffle
1
all the way back (Fig. C).
Pull the aluminium arc
1
back up to the stop
and plug the connecting plug for the lower
gooseneck lamp unit
2a
into the connecting
plug for the upper gooseneck lamp unit
8
.
Carefully push the cable with the connecting plug
into the lower section of the gooseneck lamp.
Attach the upper gooseneck light
7
with the
side guide correctly onto the aluminium baffle
1
and simultaneously into the side guides in the
lower gooseneck lamp unit.
On reverse, connect the lower and the upper
gooseneck lamp unit with two socket head
screws
9
(Fig. D).
Plug the LED driver
11
into the mains connection
socket on the gooseneck lamp.
Plug the LED driver
11
into a properly installed
socket.
Your light is now ready to use.
Switching the luminaire on / off
Switch the light on and off with the ON / OFF
switch
6
at the top of the gooseneck lamp.
You will only need to lightly touch it with your
finger (push button).