ENG
20
●
Do not spill water or other liquids on the compressor .These parts are not waterproof.
If liquid spills on these parts, please unplug the power cord and wipe off the liquid with
gauze or other soft absorbent material immediately.
●
Do not use or store the device in humid locations or outdoors. Use the device within
the operating temperature and humidity.
●
Do not overload power outlets. Plug the device into the appropriate voltage outlet.
●
Do not use extension cords. Plug the power cord directly into the electrical outlet.
●
Unplug the power cord from the electrical outlet after using the device. Never leave this
product unattended when plugged in.
●
Unplug the power cord from the electrical outlet before cleaning the device.
●
Completely read all of the instructions included the optional accessories before using
them.
●
Not to position the ME EQUIPMENT so that it is dif
fi
cult to operate the disconnection
device.
●
The power switch is used to isolate the device from the supply mains.
●
The direction of movement of the actuator of the supply mains switch is comply with
IEC 60447.
MAINTENANCE AND STORAGE
●
Keep the device out of the reach of unsupervised infants and children. The device
may contain small parts that can be swallowed.
●
Do not leave the cleaning solution in the nebulizer parts. Rinse the nebulizer parts
with clean hot tap water after disinfecting.
●
Wash the nebulizer parts after each use. Dry the parts immediately after washing.
●
Do not store the air tube with moisture or medication remaining in the air tube. This
could result in infection as a result of bacteria.
●
Store the device and the components in a clean, safe location.
●
Do not carry or leave the nebulizer with medication in the medication tank.
●
Do not place or attempt to dry the device, components or any of the nebulizer parts in a micro-
wave oven.
●
Do not wrap the power cord around the compressor (main unit).
The followings are maintenance and repair which can be taken by operator, or which
must be operated by manufacturer or distributor.
SERVICE AND MAINTEMANCE
RESPONSIBLE
Change the inhalation tube
Operater
Change the applied part
Operater
Change the air
fi
lter
Operater
Clean the surface of the device
Operater
Daily cleaning and disinfecting
Operater
All components which need to be repaired or
changed by seperating the device
Authorized service center of distrib-
utor or manufacturer
