ENG
21
WARNING
:
●
Do not modify this equipment without authorizaiton of the manufacturer
●
Do not service or maintenance the device while in use with the patient.
CARE AND DISPOSAL
●
Regularly clean the device and all accessories. It is recommended that all the accessories
should be wiped with a 3% solution of hydrogen peroxide with addition of 0.5% solution of a
detergent (for example, a laundry powder). After that, the nebulizer should be washed by a rich
jet of water. The mouthpieces and nose nozzles may be treated by boiling for 10 minutes or
autoclaving at 150°
С
. After the treatment, wipe dry all parts of the device with a soft cloth.
●
Repair the Device only in authorized organizations.
●
On expiration of the warranted service life apply from time to time to authorized repair
organizations to check the technical condition of the Device. Dispose to time to autho-
rized repair organizations to check the technical condition of the Device. Dispose of the
Device and its components according to the application local regulations. No special
requirements to disposal of this Device are de
fi
ned by the manufacturer.
USING THE DEVICE
Preparing for inhalation.
Important
!
Before using the appliance for the
fi
rst time it is nec-
essary to make a full cleaning, as described in last paragraph
«SAFETY INFORMATION».
1. Place the nebulizer in front of you on the table. Make sure the device is
turned off (power switch is in position «O»), and the power cord is not
plugged into the mains.
2. Remove the top of the nebulizer by turning it counterclockwise
(Fig.1).
3. Set the desired baf
fl
e.
Factory installed baf
fl
e inside the nebulizer is baf
fl
e «B» (Blue), which
is effective to affect the entire respiratory tract. For a more effective
impact medicines on the upper respiratory tract, set, instead of the
blue baf
fl
e, red baf
fl
e «C». For a more effective impact on the lower respi-
ratory tract – baf
fl
e «A» yellow color, which consists of two parts (Fig. 2,
fi
gures indicate the order of assembly). Graphics of the differential particle
size distribution by mass for different nozzles are shown in Fig. 4.
4. Fill the bottom of the nebulizer inhalation solution. The dosage should
not exceed the recommended by your doctor. The number of nebu-
liser solution is determined by the scratches on the case. The maxi-
mum reservoir volume of 10 ml.
5. Attach the nebuliser at the top, turning it clockwise until it stops.
6. Depending on the type of inhalation, using either a mouthpiece or nozzle or mask.
The mask, mouthpiece or nose nozzle is connected directly to the upper part of the
nebulizer (Fig.3).
Hold the nebulizer vertically.
Fig. 1
Fig. 2
