Pre-cut Value Gambrel - 4’ & 6’ Sidewalls
AssEmbLy InsTruCTIOn mAnuAL
2
Assembly Instruction Manual
© 2020 Little Cottage Co.
*Please Note: a 4’ sidewall uNit was used for Pictures showN*
5.
Set OSB sheeting in place, using the speed square,
make sure the OSB is flush with the 2x4 on both sides.
6.
Secure the OSB sheeting in place by fastening it with
2” nails to the 2x4’s every 6-8 inches.
1.
Thank you for purchasing from Little Cottage
Company!
If you have any questions during construction
please call us at 330-893-4212. You will find all components
necessary to complete your storage shed. Refer to your
buy list for specific contents which will vary by unit.
2.
Locate your rim boards and floor joist, layout as
shown.
3.
Start at the corner and use the speed square to make
sure the corner is flush and fasten with 3” nails.
4.
Next square up the floor. To square the floor, use a
tape measure to find the distance from one corner to the
other, then measure the diagonal between the remaining
2 corners. If the two measurements are the same, then
your floor is already squared. If they aren’t, adjust the the
floor until the measurements are the same.
