After the unit is opened disconnect the connector from IR board
assembly, flex the snap at one side remove IR board from
plastic cover carefully. Replace new IR board and push the
board towards plastic cover carefully. Ensure that board is
properly assembled then connect connector and close the unit.
STATUS LED/TEST SWITCH/
INFRARED ACTIVATOR BOARD
REPLACEMENT :
Page 6
MAINTENANCE and WIRING DIAGRAM
Batteries are perishable items. For best results, it is recommended
that the batteries receive an initial charge within the first six months
of the manufacture date of the fixture. The manufacture date can
be found on the outside of the unit packaging and on the UL label
as part of the Date Code / Series. The first two digits in the date
code represent the year and the second two digits represent the
month. In many cases, batteries beyond the initial charge
recommendation time frame will recover if fully charged soon after
installation. If such a battery does not recover after a full initial
charge, it should be replaced.
IMPORTANT BATTERY INFORMATION
Connector
To remove IR board, release snaps
Federal Communications Commission (FCC) Requirements:
This device complies with FCC Title 47, Part 15, Subpart B. this
device does not cause harmful interference.
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
AFFINITY
®
WIRING DIAGRAM
Battery
Status LED/
Test Switch/
Infrared
activator Board
WT Lamp
WT Lamp
FCT Lamp
AC Input Line Pin Details
Pin 1 White:
Neutral
Pin 3 Black:
HOT 120-347Vac, 50/60Hz
Pin 4 Red or Yellow:
Switched -HOT 120-347Vac , 50/60Hz
AC Input Line
(PEL Units)
Heater
Connector
Day Light Sensor
Pin 1
Pin 4
Pin 3
AC Input Line Pin Details
Pin 1 White:
Neutral
Pin 3 Black:
HOT 120-347Vac, 50/60Hz
AC Input Line
(OEL Units)
Pin 1
Pin 3
Part # 912-00021-001
Rev. C, 06/2019
© Acuity Brands Lighting, Inc. 2019
All Rights Reserved.
(PEL unit type only with photocell)
(CW option only for cold weather)