Page 2
INSTALLATION and WIRING
LIFE SAFETY SOLUTIONS
TEL: 800-705-SERV (7378)
OPENING THE UNIT
Use a flat head screw driver,
locate the slots, one on each side
and two on top, and twist screw
driver in each slot.
Top housing
slots
Front housing
Rear housing
Ground wire
AFFINITY
®
Provide each unit with a single-phase power supply from a 120 V through 347 V, 50/60Hz circuit used for normal lighting. The PEL option
provides an additional switched input connection. If Switched Hot input is connected to a live wire, the lamps will always be illuminated,
otherwise the Lamps will illuminate as a function of the photosensor.
PRODUCT DAMAGE WILL OCCUR IF THE RATED INPUT VOLTAGE IS EXCEEDED.
NOTE:
The battery must be connected to the charger board prior to applying AC power to the unit. Battery damage may occur if the
battery is connected longer than 24 hours without continuous AC power provided. See also “
Important Battery Information
”, page 6.
NOTE:
To meet the minimum illumination requirements of NFPA 101 (current Life Safety Code), the maximum mounting height
from ground of WT is 14.6 feet and of FCT is 14.6 feet
NOTE:
This unit should be mounted ONLY through a pair of the preformed keyholes onto a 4” “OCTAGON” junction box, or
through a pair of the keyhole knockouts onto a 4” “SQUARE” junction box, or using conduit entry.
1
Feed the supply leads through
the junction box and prepare the
lead ends to make connections
to the fixture leads.
On the rear housing, remove the
round
center
knockout
(1.2
”
diameter) and the desired pair of
keyhole knockouts.
JUNCTION BOX MOUNTING
-Images shown below may vary from actual product-
Route the supply leads through
the knockout and attach them to
the
respective
leads
on
the
fixture.
Attach
the
incoming
ground wire to the unit ground
wire.
2
3
4
Mount the rear housing on the junction box with suitable hardware (not supplied).
Junction boxes accommodated:
4” Square
4” Octagon
3-
1/2” Round or Octagon
Single Gang Box