Lithium Grim Sultan of Tone, Инструкция по сборке

Страница: 9 / 12

Sultan of Tone v4.1
9
Off board wiring and drilling
This version of the Sultan of Tone has integrated 3PDT print. This will save you time for off board
wiring, but It will require you to drill more precise!
Before you start you must drill the 2 footswitch holes in your enclosure. Heart to heart distance of
the footswitch holes is
76,65 mm . When using a Hammond 1590BB I suggest you drill a 13mm hole
at 75,5mm from the top and 17,7 mm from the left of the enclosure. The other 13mm hole should
be at 75,5mm from the top and 94,3 mm from the left of the enclosure.
Now put the 3PDT footswitches in the enclosure and tighten them secure. Place the PCB on the
footswitches and solder them. Remove the footswitches (and thus the PCB) and drill the holes for the
pots and switches. The rest of the pots and LEDs can be put anywhere you want, just remember that
you probably soldered the electrolyte caps on the bottom side so measure before drilling!
S
Input Jack
Tip
Sleeve
Ring
Tip
Sleeve
C
at
hode
(s
hor
t l
e
g)
Ano
de
(long
le
g)
Orange
C
at
hode
(s
hor
t le
g)
Ano
de
(long
le
g)
Red
Output Jack
Soldering the potentiometers on P1-P6 is quite simple. The square pad marks pin 1 of the
potentiometer. You can break the pin off the potentiometer circled in the bottom left picture.
3 2 1