12
Remove light kit fitter plate screw (P) located in the
non-slotted hole in light kit fitter (Q) and partially
loosen the other two light kit fitter plate screws (P).
CAUTION:
Do NOT remove screws on light kit
fitter (Q) that have washers; these are not the light
kit fitter plate screws (P).
Twist light kit fitter (Q) counterclockwise to remove it
from the inside of the light kit fitter plate (O).
2.
2
FINAL INSTALLATION
Q
P
O
P
Remove one motor plate screw (N) from motor plate
on underside of motor assembly (D) and partially
loosen the other two motor plate screws (N). Feed
molex connections from motor assembly (D)
through the middle of light kit fitter plate (O). Then,
align the slotted holes in the center of light kit fitter
plate (O) with loosened motor plate screws (N),
twisting it clockwise until it locks. Re-insert motor
plate screw (N) previously removed and securely
tighten all three motor plate screws (N).
3.
Molex
Connections
Motor Plate
3
D
O
N
Molex
Connections
4. Connect the molex connections from the motor
assembly (D) to those from the light kit fitter (Q) --
black to black and white to white. Make sure they
are secure.
Align slotted holes in light kit fitter (Q) with loosened
light kit fitter plate screws (P), then twist it clockwise
until it locks. Re-insert light kit fitter plate screw (P)
previously removed (Step 2, page 12) and tighten all
three light kit fitter plate screws (P) securely.
4
Q
P
D
Molex
Connections
