FAN MOUNTING
Depending on the length of downrod (A) you
use, you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you
have pulled them all the way through the top of
the downrod (A). Start at the TOP of the
downrod (A) and measure 8 in. of lead wire, and
then cut the excess wire off with wire cutters (not
included).
NOTE:
If you do
not
cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead
.
4.
2. Insert downrod (A) through canopy (B), canopy
cover (H) and yoke cover (L). [
NOTE:
Canopy
cover (H) must be turned with the shiny side
toward
the motor assembly (D).] Thread wires
from motor assembly (D) through downrod (A).
3.
4
A
8
Set
Screw
F
A
E
3
D
2
A
B
L
H
L
H
Slip downrod (A) into yoke at top of motor
assembly (D), align holes and re-install pin (E)
and clip (F). Re-tighten set screws in yoke and
then tighten nuts. Slide yoke cover (L) down until
it rests on top of motor assembly (D).
