9. Blade Assembly.
motor housing
blade
slot
page 7
blade attachment
screws and washers
lock washer
blade arm screw
plastic
motor
lock
10. Light Kit Assembly (Optional).
Remove 3 screws from fitter plate (on underside of
motor).
If you wish to use the fan WITH the light kit
,
connect female plug from switch housing to male
plug from motor housing. Be sure that plugs
connect completely.
Align holes in switch housing with holes in fitter
plate. Attach switch housing with the 3 screws that
were previously removed. Securely tighten all 3
screws.
Remove finial from light kit fitter.
Install 3 candelabra base 40 watt max. bulbs
(included).
Important
: When replacing bulbs, please allow
bulb(s) and glass shade to cool down before
touching them.
["Light Kit Assembly" continued on next
page.]
fitter plate
blade arm
fitter plate
finial
bulb
male plug
female plug
switch housing
and
light kit fitter
Time Saver:
Washers for blade screws can be set
on each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
one of the hardware packs. Hold blade arm up to
blade and align holes. Insert blade attachment
screws (along with washers) with fingers first and
then tighten screws securely with a Phillips
screwdriver. Repeat procedure for the remaining
blades.
Remove blade arm screws and lock washers from
fan motor and set aside. Then, if applicable, remove
plastic motor locks from underside of motor and
discard plastic motor locks (
save blade arm screws
and lock washers to secure blade arms)
. Align blade
arm holes with motor screw holes and attach blade
arm with lock washers and blade arm screws. (
Note
:
Use slot in fitter plate for easier access with
screwdriver.)
Before securing screws completely,
repeat procedure with remaining blade arms.
Secure all screws.
Note
: Tighten blade arm screws twice a year.
