page 8
Align hole in center of glass shade with threaded
rod on light kit fitter and gently push up on glass
shade. Secure glass shade with finial that was
previously removed.
NOTE
:
Do not overtighten finial as glass may crack
or break.
If you wish to use the fan WITHOUT the light kit
,
locate wires in switch housing labeled FOR LIGHT
KIT CONNECTION. Gently pull molex connections
apart in order to disconnect these wires.
Next, remove the hex nut and lock washer from
the threaded rod at the top of the light kit fitter.
Unscrew the switch housing to remove it from the
light kit fitter and then gently feed the BLACK and
WHITE wires from the light kit fitter through the
hole in the middle of the switch housing.
Locate cap in one of the hardware packs and place
firmly in hole in middle of switch housing. Connect
female plug from switch housing to male plug
from motor housing. Be sure that plugs connect
completely.
Align holes in switch housing with holes in fitter
plate and attach switch housing with 3 screws that
were removed on previous page. Securely tighten
all 3 screws with Phillips screwdriver.
10. Light Kit Assembly (Optional). (cont.)
finial
male plug
switch housing
fitter plate
female plug
switch housing
glass shade
motor housing
light kit fitter
molex
connections
cap
hex nut
lock washer
motor housing
