page 9
11. Remote Control Operation.
light dimmer setting
fan setting
12. Testing Your Fan.
LIGHT button
- Tap once to turn light ON or OFF.
Liquid crystal display shows the amount of
brightness as a percentage. Holding the button
down for more than 2 seconds will cycle light
through brightness settings. When turning the
light back ON, light will return to the same
brightness setting it was on when light was last
turned OFF.
FAN button
- cycles through 3 fan SPEEDS and
then returns to the OFF setting.
motor housing
reverse switch
It is recommended that you test fan before finalizing
installation. Restore power from circuit box and light
switch (if applicable). Test fan speeds with the FAN
button on the remote control. Test the light ON/OFF
function with remote control. Test dimmer function by
holding down the LIGHT button for more than 2
seconds.
If the remote control operates all of the functions of
the fan and light, battery has been installed correctly.
If fan and/or light do (does) not function, please refer
to "Troubleshooting" section to solve any issues before
contacting Customer Service.
Turn fan completely off
before
moving the reverse
switch. Set reverse switch to recirculate air depending
on the season:
- LEFT position in summer (
diagram 1
)
- RIGHT position in winter (
diagram 2
)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat setting
in winter without feeling a difference in your comfort.
Important
: Reverse switch must be set either
completely to the LEFT
or
completely to the RIGHT
for fan
to function. If the reverse switch is set in the
middle
position (
diagram 3
), fan will not operate.
diagram 1
diagram 2
diagram 3
