LPTC801 GB
2
3. General Guidelines
•
This device is a light controller for professional use on stages, in discos, theatres, etc. This
device should only be operated with a direct current of 20Vdc supplied by a dimmer pack e.g.
LPTP406. This device is designed for indoor use only.
•
Do not shake the device. Avoid brute force when installing or operating the device.
•
Select a location where the device will be protected against extreme heat, moisture and dust.
•
Do not use or transport the device under temperatures < 5°C or > 35°C.
•
Familiarise yourself with the functions of the device before actually using it. Do not permit
operation by unqualified people. Any damage that may occur, will probably be due to
unprofessional use of the device.
•
Use the original packaging if the device is to be transported.
•
Note that all modifications of the device are forbidden for safety reasons.
•
Do not remove the serial number sticker from the device as doing so will void the warranty.
Only use the device for its intended purpose. All other uses may lead to short-circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void
the warranty.
4. Front & Back Panel Description
1. LED indicators for each channel.
2. Dimmer slider per channel
3. FLASH buttons : push button per channel to set that channel to 100%
4. MASTER FADER : sets the output level for all channels
5. FULL-ON button : sets all channels to 100%
6. MASTER LED : indication LED for master dimming control
7. SPEED LED : indicates operation through the built-in microphone.
8. Chaser speed adjustment
9. BLACK LED indicator : all channels to 0%
10. AUDIO LED indicator : activates music-controlled operation.
11. CHASE button 1-4 + LED indicator : activation of chaser for channels 1 through 4.
12. CHASE button 5-8 + LED indicator : activation of chaser for channels 5 through 8.
13. PROG LED indicator : for programming the output power of the channels or
reversing the chaser direction.
Function : set the master fader on 100% and adjust the individual channels to the desired
output power. Hold the PROG button for ± 1 second until the LED lights up if you want to
