LITE-CHECK INSPECTOR 920
Page 12 of 36
What is included with the LITE-CHECK INSPECTOR 920?
The INSPECTOR 920 ships with the following items:
1 – LITE-CHECK INSPECTOR 920
1 – This Operations Manual
1 – Quick Reference Guide
1 – Antenna
1 – Remote Control
1 – Plastic Cover
1 – Orange Neck Pouch
Please inspect the shipment when it arrives for any missing or damaged items.
Required Materials
The following additional materials are required to operate the INSPECTOR 920:
1 – 7-way cable with 7-way plugs on both ends
2 – 1/4” air lines with glad-hands on one end
2 – Quick disconnect air connectors (male and female for tester and air lines)
1 – Filtered air regulator to provide clean 110-120psi air pressure
Note:
the above Items are available in the LITE-CHECK 302A Shop Accessory
Kit (see LITE-CHECK INSPECTOR 920 Accessories below)
1 – Power supply (either a charged 12-volt battery
OR
a regulated power supply
(such as the LITE-CHECK 311R 12VDC Regulated Power Supply))
Warning: Power to the tester must be regulated to protect the trailer’s ABS
electronics and ensure consistent tester performance.
Mounting location or plate to secure the tester
Warning:
The
LITE-CHECK
INSPECTOR 920 is a “diagnostic” tester that monitors the
current flow through the ground circuit to aid in identifying various fault conditions. Care
should be taken to insure that the tester’s case is not grounded to the trailer or tractor
under test. The 920 should not be supplied with power from the tractor under test when
testing and inspecting tractor/trailer combinations.
LITE-CHECK INSPECTOR 920 Accessories
Besides the items above, the following LITE-CHECK items are available to enhance the
INSPECTOR 920:
