Lissmac SBM-M 1000 D2, Руководство по эксплуатации

Страница: 36 / 55

Operation
5.11. Change the position of the machining units
Typically the lower machining unit
(31)
position is set to 0 mm , the upper
machining unit
(26)
is set to the material thickness. To optimise the slag
removal result for tenacious slag, the distance of the upper and lower
machining units can be reduced relative to the position of the conveying belt
or transport rollers. This reduces the distance between the material and
impact belt nipples. The pre-set material thickness then remains unchanged.
Reducing the distances must be done in millimetre sized steps and then
tested.
NOTE
Higher machining unit wear
Damage to the machine, premature wear of the impact belts

Reducing the machining unit distance relative to conveyor belt or
transport roller position by too much can lead to damage to the power-pin
belts or to the machine.

Each reduction in distance of the machining units relative to the conveyor
belt or transport roller position increases the wear of the power-pin belts.

The distance of the machining units relative to the conveyor belt or
transport rollers may only be reduced in millimetre sized steps. The
effectiveness of this must be tested after each reducing step.
To change the position of the machining units, the gear selection lever
(25)
must be set to the corresponding position. If the gear switch "catches" a little
when adjusting it
(25)
it is recommended to turn the manual wheel
(24)
at the
same time.
36 Deslagging machine SBM-M 1000 /1500 D2