Lissmac COMPACTCUT 400 E, Руководство по эксплуатации

Страница: 22 / 45

22/45
3.6. Drive belt
Danger!
Removing or opening of the saw blade protective hood or reaching into the rotating saw blade
during cutting is prohibited. These works may only be carried out with the saw blade at a
standstill and the drive motor turned off.
Inspection
Inspection of the drive belts can be done by pushing them with the thumbs.

Remove the cover (Pos. 3)

Inspection by pushing them with the thumbs
The effects of an improperly tensioned drive belt:

Drive belt too loose:
Drive belt slips on the v-belt pulley, no or low power transmission

Drive belt tightened too much:
Excessive wear, much heating of the v-belt pulley with resulting damage
Inserting and removal or re-tensioning the drive belts

Remove the saw blade protective hood and rods from the floor saw

Remove the saw blade from the floor saw (see Section 3.4)

Remove the saw blade flange (Pos. 2)

Remove the drive motor cover (Pos. 1)

By loosening the safety screw (Pos. 4), drive belts can be released or tightened

The drive belts can be removed
2
1
4
3