Lissmac CC401 E, Руководство по эксплуатации

Страница: 29 / 48

29/48
WARNING
Fall hazard
Injuries due to falling downward if the substrate cannot bear the load

Ensure the substrate on which you are cutting has a sufficient load-bearing capacity.

When cutting, make sure the floor saw and personnel are not on the side to be cut off.
CAUTION
Burn hazard
Motor parts and tools become hot during operation and can cause burns

Avoid contact with the skin

Wear personal protection equipment

Leave the motor to cool down before work on the device
6.2. Start preparations
NOTICE
Cutting without obstacles
Damage to objects in the cutting area or the saw blade.

All obstacles must be removed from the cutting area

Ensure good lighting in the work area.
Make sure the cut is straight to prevent the saw blade from jamming.
Execute all steering and control commands slowly, evenly and in a controlled manner.
If deep cuts have to be made, this must be done in several steps.
The joint should be pre-cut using a smaller (and wider) saw blade and then deepened using a larger (and
narrower) saw blade.
Preparing for start-up
The following prerequisites must be met to safely and properly use the floor saw:

Check the floor saw for damage, loose screw connections and the completeness of attached parts

Connect a reliable water supply.

Install a suitable saw blade.
 The water cooling system is functional

There are no objects or persons in the immediate vicinity of the saw blade.

Align the tracking pointer flush with the saw blade.

Lift up the saw blade – no ground contact!