Lissmac CC401 E, Руководство по эксплуатации

Страница: 14 / 48

14/48
2.4.4. Relocating the floor saw
The floor saw may only be relocated when the saw blade is stopped.
Before leaving the floor saw’s operating position, the motor must be turned off and the saw blade must
stop. A rotating saw blade poses a high risk of injury.
The parking brake must always be activated when the machine is not in use.
2.4.5. Special work in the context of using the machine
Comply with the dates and activities for configuration, maintenance and inspection as prescribed in this
operating manual, including the details regarding replacement of parts/partial equipment. These
activities may be only be carried out by authorized expert personnel.
If the floor saw has been shut down for maintenance and repair work, it must be secured to prevent it
being switched on again unexpectedly.
Before cleaning, all openings into which cleaning products must not ingress for safety and/or functional
reasons, must be covered and sealed. Electric motors, switches and plug cords are particularly at risk.
Remove covers/tape completely after finishing the cleaning work.
Always tighten loosened screw connections during maintenance and repair work.
If it is necessary to disassemble safety features for start-up, maintenance or repair, these devices must
be reassembled and checked immediately after the conclusion of maintenance and repair work!
Rotary tools with a maximum speed less than the nominal speed of the machine may not be used.
2.5. Note relating to special types of danger
2.5.1. Risks to the operator from the machine
Before leaving the floor saw’s operating position, the motor must be turned off and the saw blade must
stop.
The motor on the floor saw may only be operated for the intended use:
Floor saw and saw blade drive