5
432-LIPPERT (432-547-7378)
Rev:06.30.22
JT’s Strong Arm
™
Travel Trailer
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-002345
2.
Under front half of chassis, locate a cross-member or
center compartment with a steel floor from 6”- 18” from
front of front jacks
(Fig.4)
.
3.
Starting with one of the front scissor jacks, remove the
existing lower, inside pivot bolt; replacing with a
3/8
”x 4”
swing-bolt. Install swing-bolt from front-to-back with the
shoulder of the swing-bolt to the front side of jack.
4.
Place
3/8
” washer and
3/8
” - 16 nylon locking nut on
threaded end of swing-bolt. Tighten enough so that
the swing-bolt will only pivot by using a screwdriver for
leverage. Ensure swing-bolt tab is positioned horizontally.
5.
Remove the existing lower, outside pivot bolt; replacing
with 4” swing-bolt. Install swing bolt from rear-to-front with
shoulder of swing-bolt to rear of the jack
(Fig.5)
.
Fig.6
6”
6.
Place a
3/8
” washer and
3/8
” locking nut on threaded end
of swing-bolt and tighten as explained in Step 4. Position
swing-bolt tab vertically
7.
Repeat Steps 3-6 for opposite front jack.
8.
Apply white grease to the threads of two “T” bolts
and partially thread them into the top holes of the outer
stabilizer tubes.
9.
Remove inner stabilizer tube from assembly and discard
the plastic shipping bag. Reassemble stabilizer tubes with
the inner tube sticking out past the end of the outer tube
by 1”
(Fig.6)
.
Fig.4
Fig.5
