TME-EPIC-HURPM-R1V5.doc
Rev 1.5
Page 15 of 41
Display Backlight Connector
Connector type: Hirose DF13 8 pin (X6)
PIN Direction Signal
1
output
+12 V DC, max. 1A
2
Output
+12 V DC , max. 1A
3
Output
+5 V DC, max. 1A
4
Output
+5 V DC, max. 1A
5
Output
Signal: Backlight enable (level: 3.3 V)
6
Output
Switched Inverter Power, max. 1A (refer to
“Power Selection Jumper” below)
7
GND
8
GND
Display Voltage Selector
Jumper X4, Location is bottom between X6 (backlight connector) and X18 (supervisory connector).
Connector type: IDC6 jumper 2.00 mm.
A jumper between 1-3 or 3-5 to selects the display voltage.
A jumper between 2-4 or 4-6 to selects the backlight voltage.
Pin
Signal name
Pin
Signal name
6
+5V DC
5
+5V DC
4
Backlight voltage
3
Display voltage
2
+12V DC
1
+3,3V DC
Default setup is 3,3V for LVDS display and 12V for the inverter.
Содержание Hurricane-PM
Страница 8: ...TME EPIC HURPM R1V5 doc Rev 1 5 Page 2 of 41 Block Diagram Figure 1 Block diagram of the Hurricane PM...
Страница 12: ...TME EPIC HURPM R1V5 doc Rev 1 5 Page 6 of 41 Top Figure 3 Connectors on top of the module...
Страница 13: ...TME EPIC HURPM R1V5 doc Rev 1 5 Page 7 of 41 Bottom LVDS Backlight Supervisory...