9
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
7.
Separate the drive head from the support arm and
secure the support arm to the unit in the travel position.
THE SPRING IS UNDER EXTREME TENSION. IMPROPER
HANDLING COULD CAUSE DEATH, SERIOUS INJURY
OR PROPERTY DAMAGE.
8.
With an assistant holding the roll tube, firmly take hold of
the drive head with a pair of locking pliers
(Fig.5)
. Remove
the cotter pin, from the end cap and move the cam lock to
the roll up position. Slowly release the tension by rotating
the drive head with the locking pliers.
NOTE:
Padding the locking pliers will prevent scratching
components.
9.
Remove the 3 screws securing the end cap
(Fig.22B)
to the roll tube
(Fig.22A)
.
10.
Remove the end cap
(Fig.23C)
and spring assembly
(Fig.23B)
from the roll tube
(Fig.23A)
.
11.
Locate the cam lock marking applied in Step 1 and
slide the Solera spring assembly into the roll tube so that
the cam lock lines up with the cam lock marking.
Fig.22
A
B
12.
Place the Solera end cap onto the roll tube, making
sure it is properly seated.
A
B
C
Fig.23
13.
Secure the Solera end cap
(Fig.24C)
to the roll tube
(Fig.24A)
with the provided rivets
(Fig.24B)
.
NOTE:
It may be necessary to drill out the previous holes
in order to accommodate the larger-sized rivets.
14.
Remove the cotter pin from the end cap and move the
cam lock to the roll out position.
15.
Apply tension to the spring assembly by turning the
drive head in a counterclockwise direction. The number of
turns is determined by the position and size of the awning.
A
B
C
Fig.24
