4
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
2.
Unlock the travel locks, move the cam lock to the roll out
position and fully extend the awning.
3.
Insert a cotter pin
(Fig.2C)
into the end cap
(Fig.2A)
at
each end of the awning.
4.
Pull the idler and drive side rafter arms
(Fig.2B)
up and
lock it into the head of the support arm
(Fig.2D)
.
NOTE:
Be sure to tighten the tension knob
(Fig.3B)
on the idler
and drive rafter arms before moving on.
Fig.2
A
B
C
D
Fig.3
A
B
5.
On the drive side of the awning, release the rafter arm.
With the rafter arm lowered and out of way, have an assistant
hold the roll tube and use a
3/8
” socket to remove the bolt
securing the drive head
(Fig.4A)
to the support arm
(Fig.4B)
.
Fig.4
A
B
6.
Separate the drive head from the support arm and
secure the support arm to the unit in the travel position.
7.
With an assistant holding the roll tube, firmly take hold of
the drive head with a pair of locking pliers
(Fig.5)
. Remove
the cotter pin from the end cap and move the cam lock to
the roll up position.
NOTE:
Padding the locking pliers will prevent scratching
components.
Fig.5
8.
Slowly release all of the tension by rotating the drive
head with the locking pliers.
9.
Using an appropriately sized drill bit, drill out the rivets
attaching the end cap to the roll tube.
THE SPRING IS UNDER EXTREME TENSION. IMPROPER
HANDLING COULD CAUSE DEATH, SERIOUS INJURY
OR PROPERTY DAMAGE.
