8
lippertcomponents.com
574-537-8900
Rev: 11.17 - Solera
®
Universal Hardware Conversion
Solera
®
Universal Hardware
Manual Awning to
Solera Classic Manual Awning
(For Aftermarket Application)
3.
Insert a cotter pin
(Fig.18A)
into the end cap
(Fig.18B)
at each end of the awning.
NOTE:
Some systems do not have a hole on the drive end
cap for the cotter pin. In this instance, the cam lock
MUST
remain in the roll out position until it is time to release the
tension in the springs.
5.
On the drive side of the awning, if equipped, remove
the cam lock assist
(Fig.20B)
from the lock pin
(Fig.20A)
,
making sure the cam lock remains in the roll out position.
Fig.18
A
B
4.
At the idler side of the awning, slide the rafter arm
(Fig.19A)
up and lock it into the head of the support arm
(Fig.19C)
.
NOTE:
Be sure to tighten the tension knob
(Fig.19B)
on
the idler side of the awning before moving on to the drive
side of the awning.
A
B
C
Fig.19
A
B
Fig.20
6.
With an assistant holding the roll tube
(Fig.21A)
, remove
the fastener securing the drive head
(Fig.21B)
to the
support arm.
A
B
Fig.21
