TrainMaster Command Control operations
Tuning your locomotive’s performance
T
rainMaster Command Control allows you to fine-tune the performance of your locomotive.
Use your CAB-1 Remote Controller to make these adjustments.
Adjusting the speed
The
BRAKE
and
BOOST
buttons give you incremental control of your locomotive’s speed
while you press and hold these buttons, allowing you to make small, gradual adjustments
around curves and over grades. The locomotive will resume its initial speed when the buttons are
released.
16
15
TrainMaster Command Control operations
CAB-1 Remote Controller commands
T
he CAB-1 Remote Controller commands are detailed below.
Releases the rear coupler.
Activates the numeric keypad.
Toggles the back-up light on and off.
Accelerates the locomotive with a clockwise rotation.
Decelerates the locomotive with a counter-clockwise
rotation.
Shuts down all PowerMasters on your railroad. Stops
all TrainMaster Command Control-equipped
locomotives in operation. Use
HALT
only in
emergency situations.
Changes the locomotive’s direction. The locomotive
decelerates to a stop and continues in the opposite
direction when you increase the throttle.
Increases the locomotive’s speed while the button is
pressed. Release the button to return to the initial
speed.
Decreases the locomotive’s speed while the button is
pressed.
Stops and resets the locomotive
Turns off the smoke unit.
Turns on the smoke unit if the smoke unit switch is in
the SMK position. Be sure to add smoke fluid before
turning on the smoke unit to prevent damage to your locomotive.
AUX1
,
8
and
9
function only if the locomotive’s smoke
unit switch is in the SMK position.
Sounds will be active in both switch positions.
SET
L
M
H
Note!
L = 32 speed steps
M = 100 speed steps
H = 100 speed steps
with momentum.
